Analysis of ball mill grinding operation using mill power specific kinetic parameters

• Effect of operating variables on the energy efficiency of ball mill analyzed.
• Rates of particle breakage and production of fines per unit power input considered.
• Both the parameters exhibit significant variation with operating conditions.
• Effect of variables found to be different under different operating conditions.
• Rate of production of fines parameter better suited for mill design and scale-up.

With a view to developing a sound basis for the design and scale-up of ball mills, a large amount of data available in the literature were analyzed for variation of the two key mill performance parameters: power specific values of the ‘absolute breakage rate of the coarsest size fraction’, S*, and ‘absolute rate of production of fines’, F*, with some of the important operating and design variables such as the mill speed, ball load, particle load, ball diameter and mill diameter. In general, values of both the mill performance parameters were found to vary significantly with the mill operating conditions. The nature and relative magnitude of variation for the two parameters also differed significantly. Moreover, the effect of any particular variable on the S* and F* values was found to be significantly different for different sets of operating conditions. It has been emphasized that, as the purpose of grinding is to produce fine particles, the mill design and scale-up work should be based mainly on the F* parameters. Moreover, it is not correct to regard the S* values to be independent of the mill design and operating variables as a general rule, especially for a fine analysis of the performance of the grinding systems.

Figure optionsDownload as PowerPoint slide