Experimental investigation of nanofluid free convection over the vertical and horizontal flat plates with uniform heat flux by PIV

• The boundary layer thickness decreases with increase in the heat flux intensity.
• The fluid circulation increases by adding nanoparticles to the base fluid.
• The flow velocity increases around the plate with increase in wall heat flux.
• The velocity decreases by adding nanoparticle to the base fluid.

This paper applies the particle image velocimetry (PIV) to measure the laminar boundary layer thickness of TiO2–water nanofluid free convection over the vertical and horizontal flat plates with constant heat flux. The results are presented for two values of heat flux strength equal to 3000 and 7000 w/m2. The effects of nanoparticles and heat flux strength on the boundary layer thickness and velocity profiles are investigated in details. Finally, a comparison is performed between the experimental, theoretical and numerical results for different conditions. The obtained results revealed that the velocity boundary layer decreases by adding the nanoparticles to the base fluid. These reductions, at ϕ = 0.1%, are in the vicinity of 7.5% and 5.2% for q″=3000and7000wm-2, respectively. Also, the maximum reductions in the vertical velocity component by adding the nanoparticles at ϕ = 0.1% are in the vicinity of 4% and 3.3% for q″=3000and7000wm-2, respectively.

Figure optionsDownload as PowerPoint slide