Effect of cup and ball types on alumina–tungsten carbide nanocomposite powder synthesized by mechanical alloying

Alumina-based nanocomposite powders with tungsten carbides particulates were synthesized by ball milling WO3, Al and graphite powders. X-ray Diffraction (XRD) was used to characterize the milled and annealed powders. Microstructures of milled powders were studied by Transmission Electron Microscopy (TEM). Results showed that Al2O3–W2C composite formed after 5 h of milling with major amount of un-reacted W in stainless steel cup. The remained W was decreased to minor amount by increasing carbon content up to 10 wt.%. When milled with ZrO2 cup and balls, Al2O3–W2C composite was completely synthesized after 20 h of milling with the major impurity of ZrO2. In the case of stainless steel cup and balls with 10 wt.% carbon, Fe impurity after 5 h of milling (maximum 0.09 wt.%) was removed from the powder by leaching in 3HCl·HNO3 solution. The mean grain size of the powder milled for 5 h was less than 60 nm. The powder preserved its nanocrystalline nature after annealing at 800 °C.