کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1458213 | 989310 | 2005 | 5 صفحه PDF | دانلود رایگان |
Shrinkage of repair material, especially in patching repairs, is the major factor inducing cracking in concrete repairs. Induced cracks in repair materials are due to restrained shrinkage. Although in usual practice, the free shrinkage of the repair mortar is measured, in reality, cracking is not due to free shrinkage. It is well known that cracking is due to restrained shrinkage. It is very hard to measure the restrained shrinkage; therefore, to overcome this problem a restraint factor (R) is used to modify the free shrinkage and come up with the restrained shrinkage. The restraint factor is influenced by the surface and boundary condition.In this study, the restraint factor for patching repair with different boundary conditions (with eaves and without eaves) and surface condition (rough and smooth) of the substrate concrete is investigated.The results show that the restraint factor R lies between 0.1 and 0.94; with an increase of restraint, the restraint factor is increased. In situations with a high level of restraint (eaves at the perimeter and a rough surface of substrate), the average R is 0.83. while with a low level of restraint (without eaves at the perimeter and a smooth surface of the substrate), the average R is 0.22.
Journal: Cement and Concrete Research - Volume 35, Issue 10, October 2005, Pages 1909–1913