Properties of thermo-chemically surface treated carbon fibers and of their epoxy and vinyl ester composites

Carbon fibers were surface treated by a continuous gas phase thermo-chemical treatment. The surface and the mechanical properties of the fibers were investigated before and after treatment and compared to the properties obtained with a conventional industrial electro-chemical surface treatment. The increase of the oxygen atomic content was much sharper, the surface chemistry was better controlled, and the tensile strength of the fibers increased slightly with the thermo-chemical surface treatment. The thermo-chemical surface treatment created a topography which amplitudes were under 10 nm, thus creating some mechanical interlocking with the matrix. The electro-chemical surface treatment did not generate such a topography. The improvement of interfacial adhesion with a vinyl ester matrix was limited, revealing that oxidation of the carbon fiber surface alone cannot tremendously improve the mechanical properties of carbon fiber–vinyl ester composites.