Renewable resource based biocomposites from natural fiber and polyhydroxybutyrate-co-valerate (PHBV) bioplastic

Renewable resource based green biocomposites were prepared using a bacterial polyester i.e., poly(hydroxybutyrate-co-valerate) (PHBV) and natural bamboo fiber. Fabrication of the biocomposites was carried out by injection molding following extrusion compounding of PHBV and bamboo fiber with 30 or 40 wt.% fiber. The mechanical, thermo-mechanical and morphological properties of the biocomposites were evaluated. Little variation in the thermo-mechanical and impact properties was observed when the fiber content was varied. The tensile modulus of biocomposites at 40 wt.% fiber improved by 175% as compared to that of neat PHBV. The theoretical tensile modulus of the biocomposites was calculated using Christensen’s equations and compared with the experimental results. It was found to be in near approximation to the experimental data. The storage modulus was affected slightly by the variation of fiber content from 30 to 40 wt.% in biocomposites. The heat deflection temperature of PHBV increased by 9 °C at 40 wt.% of fiber reinforcement. Morphological aspects and thermal stability were studied using scanning electron microscopy and thermo-gravimetric analysis, respectively. In addition, a comparative analysis of bamboo fiber–PHBV with wood fiber–PHBV biocomposites was performed. Statistical analysis of both biocomposites was carried out by performing a two-way ANOVA on their tensile and flexural moduli in order to evaluate the effect of fiber type and content in the PHBV matrix.