Influence of heat treatment of powder mixture on the microstructure and optical transmission of Nd:YAG transparent ceramics

Transparent Nd:YAG ceramics were fabricated by solid-state reactive sintering of Y2O3, α-Al2O3 and Nd2O3 powders with TEOS and MgO as sintering aids. The powders were ball-milled, dried, sieved and calcined at different temperatures. Samples sintered at 1745 °C for 10 h were utilized to observe the microstructure and the optical transmission. It is found that heat treatments of the powder mixtures above 600 °C for 1 h are necessary to remove the carbon contamination but below 800 °C for 4 h can avoid strong aggregation of the powder. So there is a room for heat-treatment, between 600 °C and 800 °C that can obtain Nd:YAG ceramics with almost pore-free microstructures and high transparency. Highly transparent Nd:YAG ceramic with 84.3% in-line transmission at 1064 nm was fabricated by sintering the 800 °C-1 h-heat-treated powder mixture at 1745 °C for 50 h. Even at wavelength of 400 nm, the transmittance of the sample reached 82.9% and the optical scattering coefficient was as low as 0.71% cm−1.