Synthesis optimization of organic xerogels produced from convective air-drying of resorcinol–formaldehyde gels

Resorcinol–formaldehyde gels were produced at 50, 70 and 90 °C and with three different R/C ratios (500, 1000 and 2000). The effect of these variables combined with that of aging time was studied in order to optimize the synthesis conditions. The convective air-drying process was used, and the drying duration was studied with regard to the synthesis conditions. The aging time has no effect on the pore texture after 24 h at 90 °C or 48 h at 70 °C, whatever the R/C value. The synthesis-aging step can be shortened by increasing the temperature. Nevertheless, the pore size tends then to decrease, especially when R/C is high, but this can be counterbalanced by increasing R/C. Moreover, bubbles often appear in the gel at high synthesis temperature, which limits the temperature to about 70 °C in the case of monolithic parts. At 70 °C and with an air velocity of 2 m/s, the elimination of 90% of the solvent requires 1 h drying when the pore size reaches 400–600 nm, 2.5 h for 50 nm wide pores and 3 h when the pore size decreases to 15–20 nm. The drying duration does not exceed 8 h in all cases and could be shortened by increasing the temperature at the end of the process.