کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1520504 | 1511783 | 2016 | 15 صفحه PDF | دانلود رایگان |
• Precipitate-free electrodeposition of CdS is achievable using Thiourea precursor.
• Electrodeposition of CdS using 2-electrode configuration.
• The electrodeposited CdS shows excellent electronic properties.
• Exploration of the effect of heat treatment temperature and heat treatment duration.
CdS layers used in thin film solar cells and other electronic devices are usually grown by wet chemical methods using CdCl2 as the Cadmium source and either Na2S2O3, NH4S2O3 or NH2CSNH2 as Sulphur sources. Obviously, one of the sulphur precursors should produce more suitable CdS layers required to give the highest performing devices. This can only be achieved by comprehensive experimental work on growth and characterisation of CdS layers from the above mentioned sulphur sources. This paper presents the results observed on CdS layers grown by electrodepositing using two electrode configuration and thiourea as the sulphur precursor. X-ray diffraction (XRD), Raman spectroscopy, optical absorption, scanning electron microscopy (SEM), energy-dispersive X-ray analysis (EDX) and photoelectrochemical (PEC) cell methods have been used to characterise the material properties. In order to test and study the electronic device quality of the layers, ohmic and rectifying contacts were fabricated on the electroplated layers. Schottky barriers, formed on the layers were also compared with previously reported work on Chemical Bath Deposited CBD-CdS layers and bulk single crystals of CdS. Comparatively, Schottky diodes fabricated on electroplated CdS layers using two-electrode system and thiourea precursor exhibit excellent electronic properties suitable for electronic devices such as thin film solar panels and large area display devices.
Journal: Materials Chemistry and Physics - Volume 180, 1 September 2016, Pages 14–28