Hybridisation optimization of concentrating solar thermal and biomass power generation facilities

• Comparison of 17 different CSP–biomass hybrid concepts using mature CSP & biomass technologies.
• 13% Net efficiency increase between different scenarios.
• Up to 69% cost reduction with hybrids when comparing annual generation with standalone CSP.
• Technical, economic, environmental analysis comparing hybrid and standalone CSP systems.
• Consideration of thermal storage to increase annual generation.

Recently, the first concentrating solar power–biomass hybrid power plant commenced operation in Spain and the combination of both energy sources is promising to lower plant investment. This assessment investigates 17 different concentrating solar power–biomass hybrid configurations in regards their technical, economic and environmental performance. The integration of molten salt thermal storage is considered for the best performing hybrid configuration. While thermal storage can increase plant output significantly even 7 h full-load thermal storage plants would generate the majority of the electricity, 70%, from the biomass resource.Only mature technologies with references >5 MWe are considered in this assessment to ensure that the scenarios are bankable. The concentrating solar power technologies selected are parabolic trough, Fresnel and solar tower while the biomass systems include grate, fluidised bed and gasification with producer gas use in a boiler.A case study approach based on the annual availability of 100,000 t of wood biomass is taken to compare the different plant configurations but the results are transferable to other locations when updating site and cost conditions. Results show that solar tower–biomass hybrids reach the highest net cycle efficiency, 32.9%, but that Fresnel-biomass hybrids have the lowest specific investment, AU$ 4.5 m/MWe. The investment difference between the 17 scenarios is with up to 31% significant. Based on the annual electricity generation CSP–biomass hybrids have an up to 69% lower investment compared to standalone concentrating solar power systems. The scenario with the best technical performance, being solar tower and gasification, is at this point in time not necessarily the best commercial choice, being Fresnel and fluidised bed, as the lower Fresnel investment outweighs the additional electricity generation potential solar towers offer. However, other scenarios with different benefits rank closely.