Microstructures and mechanical properties in dissimilar AZ91/AZ31 spot welds

The stir zone microstructures and mechanical properties of dissimilar AZ91/AZ31 friction stir spot welds made using different tool designs and tool rotational speed settings are investigated. Intermingled AZ91 and AZ31 lamellae are formed in the stir zones of dissimilar spot welds made using threaded, three-flat/0.7 mm/threaded and three-flat/no-thread tools and tool rotational speeds ranging from 1500 to 3000 rpm. The intermingled lamellae have chemical compositions, which are similar to those of the upper and lower sheets in the dissimilar sandwich. The flats on the rotating tool facilitate the downward transfer of upper and lower sheet materials in the location close to the pin periphery and therefore intermingled AZ91 and AZ31 lamellae are formed in the stir zones of dissimilar spot welds produced using a three-flat tool without a thread.The distance (Y) from the tip of the hook region to the keyhole periphery has a dominant influence on the mechanical properties of dissimilar AZ91/AZ31 spot welds, since the hook regions are curved inwards towards the axis of the rotating tool. The highest failure load properties and largest Y-values are found in dissimilar spot welds made using threaded and three-flat/0.7 mm/threaded tools and tool rotational speeds from 1500 to 3000 rpm. Dissimilar spot welds made using a rotational speed of 1000 rpm have the smallest Y-values and the lowest failure load properties.