کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1577327 | 1514801 | 2012 | 13 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Dynamic recrystallization of the H- and O-tempered Mg AZ31 sheets at elevated temperatures Dynamic recrystallization of the H- and O-tempered Mg AZ31 sheets at elevated temperatures](/preview/png/1577327.png)
Uniaxial tensile properties influenced by the dynamic recrystallization (DRX) behavior of the partially strain-hardened magnesium AZ31 sheets (H24) containing scores of twins were investigated and compared to those of fully annealed ones (O) with absence of twins. For this purpose, a series of uniaxial tensile tests were carried out for the H24 and O materials at temperatures ranged from room temperature to 300 °C and at strain rates between 10−3 and 10−1 s−1. At 150 and 200 °C, the H24 material exhibited higher yield strength without much loss in elongation compared to those of the O material; this trend was attributed to the continuous DRX along or around grain boundaries as well as extensive twin-aided DRX inside grains. In addition, the post-deformation hardness value of the H24 material showed higher than that of the O material. On the other hand, at higher temperatures of 250 and 300 °C, it was observed that twins shown in the H24 material were disappeared even prior to deformation, resulting in the similar grain structure and mechanical property values to those of the O material, e.g., discontinuous DRX associated with grain boundary bulging. Finally, the initiation of DRX was rationalized in terms of microstructure morphology, deformation temperature and strain rate, and then modeled in the context of strain hardening rate analysis. A comparison of experimental results and predictions for both H24 and O materials showed that the model can provide a reasonable prediction of critical strain to initiate DRX.
► Low-temperature DRX of H- and O-tempered Mg AZ31 sheets was investigated.
► The H sheet exhibited extensive continuous DRX as well as twin-aided DRX.
► Ductility of H sheet was close to that of O one despite of its higher yield stress.
► Post-deformation hardness of H sheet was higher than that of O one.
► Critical strain to initiate DRX of H sheet was much lower than that of O one.
Journal: Materials Science and Engineering: A - Volume 542, 30 April 2012, Pages 127–139