Orientation dependencies of mechanical response, microstructure and texture evolution in hot compression of AZ31 magnesium alloy processed by equal channel angular extrusion

The anisotropic mechanical behavior during hot compression of an AZ31 Mg alloy processed by equal channel angular extrusion (ECAE) was evaluated and then discussed in correlation with the concurrent microstructure and texture evolution. The results revealed apparent orientation-dependencies in the mechanical responses, microstructure, and texture development in uniaxial compression along two perpendicular directions. Compression along the transverse direction (TD) led to a higher hardening rate, higher peak stress, and earlier softening than those obtained in compression along the extrusion direction (ED). This can be attributed to the differences in the initial textures prior to compression along the two directions, which led to a more significant contribution of tensile twinning at the early stage of straining and consequently more extensive dynamic recrystallization in loading along TD than along ED. These results suggest that the deformation behavior in compressive loading of the ECAE-processed Mg alloy is highly anisotropic, which needs to be taken into account in their applications.

► An AZ31 Mg alloy was processed by ECAE to two passes.
► Hot compression tests along transverse (TD) and extrusion direction (ED).
► Higher hardening rate and earlier softening in compression along TD.
► More extensive dynamic recrystallization and rapid texture evolution in TD-compression.
► Twinning contributed to deformation at an earlier stage in TD-compression.