کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1579667 | 1001229 | 2010 | 7 صفحه PDF | دانلود رایگان |

The combined and separate effects of microstructural scale and silicon phase morphology on the mechanical properties of Al–Si eutectic alloys are investigated here. The Bridgman-type gradient-zone directional solidification method is employed to produce as-cast structures characteristic of the full range of practical (i.e. casting) growth velocities, and the corresponding mechanical properties are characterized by uniaxial tension testing. The results are analyzed in light of previously reported microstructural changes associated with the flake to fiber or “quench modification” transition [1]. Both tensile strength and elongation were found to increase with solidification rate. Application of the Nan–Clarke [2] micromechanical analysis to the Al–Si composite structure, incorporating the strengthening effects of reinforcement-induced dislocations, suggests that the decreasing microstructural scale alone is sufficient to account for the increase in tensile strength with solidification rate. However, the flake to fiber transition was found to have a particular relevance with regard to the fracture behavior of the alloy, increasing tensile elongation and decreasing the overall variability of tensile properties. A maximum in elongation was observed at approximately 600 μm/s, corresponding to the upper threshold of the flake to fiber transition associated with complete disappearance of the flake morphology and dominance of the fibrous structure. These results emphasize the importance of understanding and controlling the flake to fiber transition that occurs with increasing solidification rate in Al–Si eutectic alloys.
Research highlights▶ The influence of solidification rate on tensile strength was investigated. ▶ Analytical micromechanical modeling was used to understand strengthening mechanisms. ▶ The flake-fiber transition was found to dramatically increase tensile elongation.
Journal: Materials Science and Engineering: A - Volume 528, Issue 1, 25 November 2010, Pages 226–232