کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1585310 | 1514914 | 2006 | 7 صفحه PDF | دانلود رایگان |

Carbon nanotubes (CNTs) have been considered as an ideal reinforcement to improve the mechanical performance of monolithic materials. However, the CNT/metal nanocomposites have shown lower strength than expected. In this study, the CNT reinforced Cu matrix nanocomposites were fabricated by spark plasma sintering (SPS) of high energy ball-milled nano-sized Cu powders with multi-wall CNTs, and followed by cold rolling process. The microstructure of CNT/Cu nanocomposites consists of two regions including CNT/Cu composite region, where most CNTs are distributed, and CNT free Cu matrix region. The stress–strain curves of CNT/Cu nanocomposites show a two-step yielding behavior, which is caused from the microstructural characteristics consisting of two regions and the load transfer between these regions. The CNT/Cu nanocomposites show a tensile strength of 281 MPa, which is approximately 1.6 times higher than that of monolithic Cu. It is confirmed that the key issue to enhance the strength of CNT/metal nanocomposite is homogeneous distribution of CNTs.
Journal: Materials Science and Engineering: A - Volume 430, Issues 1–2, 25 August 2006, Pages 27–33