Study of the role of Ta and Cr additions in the microstructure of Nb–Ti–Si–Al in situ composites

Niobium silicide-based in situ composites are Nb-base alloys with high Si content that have the potential for higher temperature capability than the Ni-base superalloys. Microstructure-property studies of these alloys have been the subject of many research programmes, where the differentiation between the αNb5Si3 and βNb5Si3 is usually not clear, even though it is essential to understanding the solidification of the alloys and the stability of their microstructures at high temperatures. In this work, the effects of Cr (5 or 8 at.%) and Ta (6 at.%) in the microstructures of as-cast and heat-treated Nb–24Ti–18Si–5Al in situ composites have been studied. The main phases observed in the as-cast and heat-treated (100 h at 1400 or 1500 °C) alloys were the niobium solid solution, (Nb,Ti)ss, the niobium 5–3 silicides, αNb5Si3 and βNb5Si3, and a Cr-rich C14 silicide Laves phase. During solidification, Al additions promoted the formation of βNb5Si3, while the Cr additions caused the appearance of the C14 silicide Laves phase that was probably formed congruently from the remaining liquid. During heat treatment, the βNb5Si3 phase transformed to αNb5Si3 according to the reaction βNb5Si3→αNb5Si3+(Nb,Ti)ss. The Cr addition lowered the melting temperature of the alloys as liquation was observed after 100 h at 1500 °C in the two Cr-rich alloys. Ta and Cr retard the βNb5Si3→αNb5Si3+(Nb,Ti)ss transformation. Solid state diffusion was sluggish in the presence of Ta, but the Ta addition did not destabilize the three-phase equilibrium among (Nb,Ti)ss, αNb5Si3 and the C14 silicide Laves phase, in the Nb–24Ti–18Si–6Ta–8Cr–4Al alloy.