An investigation on metallurgical characteristics of tungsten based tool materials used in friction stir welding of naval grade high strength low alloy steels

• The process was done in “worst-case set-up”
• A designated tool holder with cooling arrangement was also not used to hold the tool.
• Tool cost is also considered as important factor, which restricts the application of FSW technology for steels.

A non-consumable tool is a vital requirement for friction stir welding (FSW) of high melting point alloys such as steel and titanium. In this investigation, an attempt was made to understand the pre-weld and post-weld microstructural characteristics of three tungsten based alloy FSW tools viz. 90%W, 95%W and 99%W. A naval grade high strength low alloy (HSLA) steel plates of 5 mm thickness were welded using the above tools with a tool rotational speed of 600 rpm and welding speed of 30 mm/min. Microstructural characteristics of the FSW tools, before and after welding, were analyzed using optical microscopy (OM) and scanning electron microscopy (SEM) with energy dispersive spectroscopy (EDS). From this investigation, it is found that the tool made of 99% W doped with 1% La2O3 exhibited microstructural stability at elevated temperatures during FSW process.