Elastic Modulus of 304 Stainless Steel Coating by Cold Gas Dynamic Spraying

304 stainless steel coating was deposited on the IF steel substrate by cold gas dynamic spraying (CGDS), and the elastic modulus of the 304 stainless steel coating was studied. The elastic modulus of cold sprayed 304 stainless steel coating was measured using the three-point bend testing and the compound beam theory, and the other mechanic parameters (such as the equivalent flexural rigidity and the moment of inertia of area) of the coatings were also calculated using this compound beam theory. It is found that the calculated results using the above methods are accurate and reliable. The elastic modulus value of the cold sprayed 304 stainless steel coating is 1. 179 × 105 MPa, and it is slightly lower than the 304 stainless steel plate (about 2 × 105 MPa). It indicates that the elastic modulus of the cold sprayed coatings was quite different from the comparable bulk materials. The main reason is that the pores and other defects are existed in the coatings, and the elastic modulus of the coatings also depends on varies parameters such as the feed stock particle size, porosity, and processing parameters.