The influence of the charged back side on the transmission of highly charged ions through PC nanocapillaries

We have measured the fraction of the ions transmitted through nanocapillaries with their initial charge state for 200 keV Xe7+ ions impact on a polycarbonate (PC) foil with a thickness of 30 μm and a diameter of 150 nm. An Au film was evaporated on both the front and back side. It is found that more than 97% of the transmitted ions remain in their initial charge state. Then, the transmitted ion fraction and the characteristic tilt angle of 40 keV Xe7+ ions through this foil and another one with the same thickness and diameter, but evaporated by Au only on the front side, were measured. By comparing the results of these two foils, the influence of the ions deposited in the capillary exit region on the transmitted ion fraction and the characteristic tilt angle is studied. In comparison with the foil evaporated by Au on both sides, the maximum transmitted ion fraction of the foil evaporated by Au on the front side only is nearly 4 times smaller. Also, the characteristic tilt angle is slightly decreased. These results are discussed within the models for the guiding effect.