Mid-frequency PECVD of a-SiCN:H films and their structural, mechanical and electrical properties

The mid-frequency pulsed plasma enhanced chemical vapour deposition (PECVD) of hydrogenated amorphous silicon carbonitride (a-SiCN:H) was investigated to prove the suitability of these films as a mechanical stiff insulator for the integration of piezoelectric fibres in microstructured aluminium plates. For the a-SiCN:H deposition trimethylsilane (SiH(CH3)3; 3MS) and nitrogen in mixture with argon were used. The films were characterised regarding their deposition rate, elastic modulus and hardness (nanoindentation), mechanical stress, elemental composition (ERDA) and electrical insulating properties.The breakdown field strength of μm-thick a-SiCN:H films is in the range of 2–4 MV/cm. At pressures of a few Pa the deposition rate reached values up to 6 μm/h. It is limited by the power absorption in the 100 kHz bipolar-pulsed discharge. Varying the pressure from 2 Pa to 15 Pa has only little influence on the film composition. With increasing pressure during deposition the elastic modulus of the films decreases from about 146 GPa to 100 GPa and the compressive film stress from 1.2 GPa to 0.55 GPa. By reducing the 3MS flow rate from 50 sccm to 10 sccm (at 8 Pa deposition pressure), the carbon and the hydrogen concentrations in the films were reduced by about 10 at. %. The Si-content is only slightly reduced but the N-content is more than tripled. In contrast, the changes in the mechanical film properties are comparatively small. The mechanical properties of a-SiCN:H films are not simply correlated to the stoichiometry but are rather controlled by the ion bombardment during growth.