Field emission from zinc oxide nanostructures and its degradation

Arrays of zinc oxide (ZnO) nanowires and nanobelts were synthesized by the thermal evaporation of mixed powders of ZnO and graphite. Neither catalyst nor vacuum environment was involved in the fabrication. For comparison, the ZnO nanowires were grown on a pre-deposited transitional ZnO film on a brass substrate and the ZnO nanobelts were grown directly on a Si substrate. Their field emission properties were systematically measured. Current density of 10 μA/cm2 was achieved at the fields of 5.7 and 6.2 V/μm from the nanowires and nanobelts, respectively. Also, the emission sites were found to distribute uniformly on the whole cathode. In the preliminary test on the stability, the ZnO nanobelts, which were sharp at the tip but wide at the root, exhibited better robustness than the ZnO nanowires. The post-test scanning electron microscopy (SEM) observation showed that the degradation of their field emission capability resulted from the breaking of the nanowires, which was tentatively attributed to the resistive heating during the field emission. In contrast, the shedding of the ZnO from the substrate was not so serious as imagined.