Experimental study on the PRE-X vehicle focusing on the transitional shock-wave/boundary-layer interactions

This article is devoted to the experimental works carried out in the R2Ch blow-down wind tunnel in the framework of the atmospheric re-entry PRE-X demonstrator program and to the fundamental studies performed on a hollow cylinder-flare relative to crucial problem of the transitional shock-wave/boundary-layer interaction.Shock-wave/boundary-layer interactions in hypersonic flows may have major consequences on thermal loads, especially if the shock is strong enough to induce separation. The heat-flux density levels in the interaction region strongly depend on the nature, laminar or turbulent of the boundary-layer. Special attention should be paid to transitional interactions, which are likely to exist at altitude where the Mach number is high and the density low.The wide Reynolds number range achievable in the R2Ch facility and reliable heat-flux measurements by infrared thermography have allowed to investigate the viscous interaction on the deflected flaps of the demonstrator model and to point out the laminar-to-turbulent boundary-layer natural and forced transition, in the light of the in-depth analysis of results obtained from the hollow cylinder-flare study.