On the heating modulation frequency dependence of the photopyroelectric signal in experiments for liquid thermal characterization

A pyroelectric sensor can be seen as a layered system consisted on a pyroelectric material sandwiched between two thin metal layers acting as electrical contacts for measurements of the voltage drop that can be induced by heating. This kind of sensor can be used as a detector of electromagnetic radiation but also for thermal characterization of materials using the photopyroelectric technique. In this work we perform a theoretical analysis based in the so-called thermal wave approach to show that, when this sensor is heated periodically by the absorption of intensity modulated light by one of the metalized surfaces, while the other metal surface is in contact with a liquid sample, the resulting pyroelectric voltage signal amplitude enhances respecting the one resulting from the bare sensor, for certain values of the modulation frequency. This contradicts the intuitively expectation based in the assumption that the sample provides a new channel for heat conduction, thereby decreasing the pyroelectric temperature. We will show that the back and forth propagation and the superposition of thermal waves through the metal coatings must be taken into account in order to explain the observed behavior. The proposed model was experimentally tested for water and glycerin samples, and using a polyvinylidene difluoride (PVDF) polymer film, with Ni–Cu metal electrodes, as a pyroelectric sensor.

► We explain the behavior of a pyroelectric signal due to periodical heating.
► Normalized amplitude is a quotient of that with a liquid sample to that without it.
► For certain modulation frequencies the normalized amplitude is greater than 1.
► The effect was explained with a model based in thermal wave interference.
► Thermal wave propagation in sensor metal coating layers must be taking into account.