Tuning magnetic fingerprints of FeNi nanowire arrays by varying length and diameter

• Fabrication of highly ordered FeNi NW arrays into AAO templates using a pulsed ac electrodeposition technique.
• Investigation of composition, crystalline characteristics and magnetic properties.
• Characterization of magnetic fingerprints using the first-order reversal curve (FORC) analysis.
• Revealing different magnetic domain states depending on the length and diameter of NWs.
• Distinguishing the irreversible and reversible components of magnetization.

Magnetic nanowires (NWs) electrodeposited into solid templates are of high interest due to their tunable properties which are required for magnetic recording media and spintronic devices. Here, highly ordered arrays of FeNi NWs with varied lengths (ranging from 2.5 to 12 μm) and diameters (between 45 and 75 nm) were fabricated into anodic aluminum oxide templates using a pulsed ac electrodeposition technique. X-ray diffraction patterns along with energy dispersive spectroscopy indicated the formation of Fe70Ni30 NWs with fcc and bcc alloy phases, being highly textured along the bcc [110] direction. Magnetic properties were studied by hysteresis loop measurements at room temperature and they showed reductions in coercivity and squareness values by increasing length and diameter. Further, magnetic fingerprints of the NWs were characterized using the first-order reversal curve (FORC) analysis. FORC measurements revealed that, with increasing length and diameter from 2.5 to 10 μm and 45–55 nm, respectively, besides an increase in inter-wire magnetostatic interactions, a transition from a single domain (SD) state to a pseudo SD state occurred. Moreover, a multi-domain (MD) state was found for the longest length and diameter. While the irreversible magnetization component of the SD NWs was approximately 100%, the reversible component of MD NWs increased up to 20%.