Effects of controllable process factors on Al rear surface bumps in Si solar cells

High efficiency solar cells require good back surface field passivation and high back reflectance in the rear Al region. In module processes, wafer-based solar cell can break through stress during soldering uneven rear aluminum surfaces - a serious problem that affects throughput. This work examined rear surfaces with respect to controllable process factors such as ramping and cooling rates during rapid thermal processing, and the fineness of aluminum powder used in the screen-printed paste. A faster ramp up rate resulted in a uniform temperature gradient between the aluminum and silicon surfaces. As a results, the bumps on the aluminum surface were small and of high density. Fine aluminum metal powder in the paste for screen-printing contact points resulted in large distribution, high density bumps. Bumps formed during cooling in metallization, their sizes and densities were dependent the on uniformity of the aluminum and silicon liquid wetting of the silicon surface.

► We discuss the formation of bump on Al electrode in solar cells with rapid thermal process.
► The effects of Al powder’s fineness on screen-printed contact points and diffusion in the Al–Si liquid phase were also investigated.
► The uniformity of the initial diffusion between the Al–Si liquid phase and the Si wafer was related to bump formation and density.