Microstructure and soft magnetic properties of Finemet-type ribbons obtained by twin-roller melt-spinning

Soft magnetic ribbons of Finemet-type (Fe73.5Cu1Nb3Si13.5B9) alloys are synthesized by the twin-roller melt-spinning technique directly from the melt, at tangential wheel speeds of 15, 18, 19 and 20 m/s. The microstructure and the magnetic properties are characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), differential thermal analysis (DTA), thermo-gravimetric analysis (TGA) and hysteresis loops measurements. Samples cooled at 20 m/s are amorphous, while those quenched at lower wheel speeds are partially crystalline. All samples studied present saturation magnetization values (150–160 A m2/kg) higher than the commercial Finemet alloys (∼135 A m2/kg), obtained by controlled crystallization of amorphous single-roller melt-spun alloys. Optimal soft magnetic properties – σS=(154±8) A m2/kg and HC=(6.9±0.9) A/m – are found in samples quenched at 19 m/s, consisting of size-distributed bcc Fe–Si nanograins (∼18 nm in average) embedded in an amorphous residual matrix. A minority nanocrystalline magnetic phase (≤10 nm) is also detected.