Configurable electronics with low noise and 14-bit dynamic range for photodiode-based photon detectors

We describe the principles and measured performance of custom configurable 32-channel shaper/digitizer Front End Electronics (FEE) cards with 14-bit dynamic range for gain-adjustable photon detectors. The electronics has been designed for the PHOS calorimeter of ALICE with avalanche photodiode (APD) readout operated at −25 °C ambient temperature and a signal shaping time of 1 μs. The electronics has also been adopted by the EMCal detector of ALICE with the same APD readout, but operated at an ambient temperature of +20 °C and with a shaping time of 100 ns. The CR-RC2 signal shapers on the FEE cards are implemented in discrete logic on a 10-layer board with two shaper sections for each input channel. The two shaper sections with gain ratio of 16:1 are digitized by 10-bit ADCs and provide an effective dynamic range of 14 bits. Gain adjustment for each individual APD is available through 32 bias voltage control registers of 10-bit range. The fixed gains and shaping times of the pole-zero compensated shapers are defined prior to FEE production by the values of a few R and C components. For trigger purposes, “fast OR” outputs with 12-bit dynamic range are available. FPGA based slave logic, combined with a USB processor supports a variety of remote control and monitoring features, including APD gain calibration. The measurements presented here for APDs at −25 °C ambient temperature and 1 μs shaping time achieve an average RMS noise level of 0.25 ADC counts or 290 electrons.The linearity over the dynamic range is better than 1%, as is the uniformity of shaping time and gain over 32 channels. Due to the excellent correspondence of the output pulse shape with offline fit, a differential timing resolution of less than 1.5 ns between channels has been achieved at ca. 2 GeV, i.e. at 1.5% of the dynamic range of PHOS.