Evaluation of flow properties of toner powder using conical rotor

In order to accurately evaluate the dynamic flow properties of toner powder, a new rotary shearing tester with a conical rotor was developed. This instrument was equipped with an automatic pressing system to compress toner powder. The tester could simultaneously measure torque and compression load during the intrusion and rotation of the conical rotor into the same packed toner powder. The optimum rotational speed and intrusion rate of the conical rotor for the characterization of the flow properties of toner powder were discussed based on test results; their values were calculated as 0.017 s− 1 and 0.083 mm/s, respectively. The torque of toner powder changed in proportion to the cube of the depth of intrusion in the toner powder bed. The surfaces of toner powder samples prepared from polymer resin and carbon pigment particles were coated with fine particles (SiO2, TiO2) under a different condition. The flow characteristics of toner powder with a different particle surface were evaluated based on the relationship between the shearing torque and the void fraction of packed toner. In the present case, the Rumpf model was applied to estimate the shearing force H at the contact point between two particles of toner powder. The value of H for toner powder with a rough particle surface, which was covered with fine particles (SiO2, TiO2), was 41 nN, while that for toner powder with a smooth particle surface, which was not covered with fine particles, was 357 nN. Further the effects of the particle shape of the toner on the torque of toner powder after compression under the same conditions were investigated. The torque of toner powder decreased with an increase in circularity.

In order to accurately evaluate the dynamic flow properties of toner powder, a new rotary shearing tester with a conical rotor was developed. This instrument was equipped with an automatic pressing system to compress toner powder. The flow characteristics of toner powder with a different particle surface were evaluated based on the relationship between the shearing torque and the void fraction of packed toner.Figure optionsDownload as PowerPoint slide