An experimental investigation on the low velocity impact response of composite plates repaired by VARIM and hand lay-up processes

This paper presents results of an experimental investigation on the impact response of repaired and unrepaired glass/epoxy composite plates. Repaired samples were prepared by two different manufacturing methods; vacuum assisted resin infusion process and hand lay-up technique. In order to compare impact response of the repaired and unrepaired samples a number of single impact tests were performed under various impact energies. Damage process of the samples is analyzed from cross-examining load–deflection curves and damaged specimens. From the visual inspection, for the impacted side of the samples, it is noted that the main damage modes for repaired samples are matrix and fiber cracks around point of impact and delaminations while severe matrix cracks expanded through fiber directions are the dominant damage mode for unrepaired samples. At the back surfaces, delaminations and fiber–matrix debonding oriented in the fiber directions are observed for unrepaired samples. However, for repaired samples the fiber fractures through repair line as well as the delaminations become dominant modes. For a reasoning justification in discussing impact test results, interlaminar fracture toughness (Mode I and Mode II) and flexural tests for repaired and non-repaired samples were also conducted.