کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
5007242 | 1461605 | 2017 | 7 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
High speed pulsed laser cutting of LiCoO2 Li-ion battery electrodes
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
سایر رشته های مهندسی
مهندسی برق و الکترونیک
پیش نمایش صفحه اول مقاله
![عکس صفحه اول مقاله: High speed pulsed laser cutting of LiCoO2 Li-ion battery electrodes High speed pulsed laser cutting of LiCoO2 Li-ion battery electrodes](/preview/png/5007242.png)
چکیده انگلیسی
Laser cutting of Li-ion battery electrodes represents an alternative to mechanical blanking that avoids complications associated with tool wear and allows assembly of different cell geometries with a single device. In this study, laser cutting of LiCoO2 Li-ion battery electrodes is performed at up to 5m/s with a 1064nm wavelength nanosecond pulsed fiber laser with a maximum average power of 500W and a repetition rate of up to 2MHz. Minimum average cutting power for cathode and anode multi-layer films is established for 12 parameter groups with velocities over the range 1-5m/s, varying laser pulse fluence and overlap. Within the tested parameter range, minimum energy per unit cut length is found to decrease with increasing repetition rate and velocity. SEM analysis of the resulting cut edges reveals visible clearance widths in the range 20-50μm, with cut quality found to improve with velocity due to a reduction in lateral heat conduction losses. Raman line map spectra reveal changes in the cathode at 60μm from the cut edge, where bands at 486cm-1 and 595cm-1, corresponding to the Eg and A1g modes of LiCoO2, are replaced with a single wide band centered at 544cm-1, and evidence of carbon black is no longer present. No changes in Raman spectra are observed in the anode. The obtained results suggest that further improvements in cutting efficiency and quality could be achieved by increasing the repetition rate above 2MHz, thereby improving ablation efficiency of the metallic conductor layers. The laser source utilized in the present study nonetheless represents an immediately available solution for repeatability and throughput that are superior to mechanical blanking.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Optics & Laser Technology - Volume 94, 1 September 2017, Pages 90-96
Journal: Optics & Laser Technology - Volume 94, 1 September 2017, Pages 90-96
نویسندگان
Adrian H.A. Lutey, Alessandro Fortunato, Simone Carmignato, Maurizio Fiorini,