Comparison of some mechanical properties and micro-topography of a component with non-axisymmetric geometry manufactured by cold orbital and hot forging

The Vickers test method was employed for hardness testing of both types of forgings. Hardness was measured at different points and relevant cross sections with the goal to obtain fine distribution of this parameter. In the next step, based on the measured hardness values, tensile strength was calculated using the hardness-strength correlation. Metallographic examinations of the surface structure as well as micro-hardness measurement of the ferrite phase were also carried out at the different cross sections of the components. Observed microstructure was analyzed and associated with the results of mechanical testing. Furthermore, a numerical analysis of the investigated cold orbital forging process was performed using commercial software package Simufact.forming and Finite Element (FE) approach.