Research on improvement of machining accuracy of micro-rods with electrostatic induction feeding ECM

Micro-rods were machined by electrochemical machining using the electrostatic induction feeding method, with which ultra-short current pulse duration of several tens of ns can easily be obtained. A tungsten plate and stainless steel (SUS304) rod were used as the tool electrode and workpiece, respectively. To improve the machining accuracy, the machining characteristics when the workpiece is fed in the axial and radial directions were investigated using NaCl aqueous solution as the electrolyte. When fed in the axial direction, the machinable length of the micro-rods was found to peak at the optimum feed speed because of the influence of pitting corrosion and collision between electrodes. When the workpiece was fed in the radial direction, the influence of pitting corrosion decreased, however, the micro-rod was shortened with increasing feed distance in the radial direction because of the stray current flowing through the end of the micro-rod. The simulation results of the material removal process agreed qualitatively with experimental results. Next, machining characteristics were compared between the electrolytes, NaCl and NaNO3 aqueous solutions, by feeding the workpiece in the axial direction. It was found that the influence of pitting corrosion was eliminated with the NaNO3 aqueous solution, and there was no machinable length limitation with suitable feed speeds. In addition, the taper angle and gap width were smaller with the NaNO3 aqueous solution, compared with those of the NaCl aqueous solution. Stainless steel micro-rods of 100 μm in diameter with a high aspect ratio of 20 were fabricated with the NaNO3 aqueous solution. According to the preliminary research results, the machinable minimum diameter of the micro-rods was investigated and micro-rods with an average diameter of 9 μm and length of 78 μm were machined successfully.