Single fibre model composite: Interfacial shear strength measurements between reactive polyamide-6 and cellulosic or glass fibres by microdroplet pullout test

This work aims to study the effect of reactive molding on polyamide-6 (PA6) based micro composites with either glass or high tenacity viscose as fibre reinforcements. For this purpose, microdroplet pullout test was found to be well suited to determine the interfacial shear strength. For pull-out testing, samples are prepared with a common method implying melting polyamide-6 and an innovative method which allows the microdroplets formation by direct wetting in the reactive mixture. Conditions to obtain microdroplet in this new method are close to those of real size composite molding. First, this work focus on the verification of the new sample preparation method using 1H and 13C NMR to determine conversion rate and verify the presence of polyamide-6 on wetted fibres bundles. Contact angle are calculated to confirm the NMR analysis conclusions. Both of these analyses confirm that PA6 is effectively formed on fibres when wetting with the reactive mixture. Finally, interfacial shear strength is compared for both glass and high tenacity viscose with these two types of preparation procedures. Obtained values for glass fibres are τ = 25 ± 6 MPa with PA6-melting and τ = 20 ± 3 MPa with reactive mixture wetting. Reactive mixture wetting also allows to avoid high tenacity viscose degradation during PA6 formation, leading to the determination of the interfacial shear strength τ = 12 ± 3 MPa.