Effect of complexing agents and pH on microstructure and tribological properties of Co-W coatings produced by double pulse electrodeposition

The Co-W coatings were produced by double pulse electrodeposition from aqueous bath with cobalt sulphate and sodium tungstate. Effect of complexing agent and pH value in the plating bath on the microstructure, morphology and hardness of the electrodeposited Co-W coatings were investigated using an X-ray diffraction (XRD), scanning electron microscope (SEM) and a Vickers hardness tester, respectively. The friction and wear properties of the Co-W coatings deposited from different baths were evaluated with a ball-on-disk UMT-3MT tribometer. The correlation among the electrodepositing condition that varied with the complexing agent or pH value, the microstructure and the tribological properties of the deposited Co-W coatings were discussed. The results show that the complexing agent and pH value significantly affect the microstructure and tribological properties of the electrodeposited Co-W coatings. The sodium citrate is the best complexing agent to improve the tribological properties of the electrodeposited Co-W coatings at pH 6.0, followed by the sodium gluconate. The Co-W coatings electrodeposited from the near neutral bath can obtain better tribological properties than those deposited from strong acid or strong alkaline bath. The differences of the tribological properties for Co-W coatings from different baths were attributed to their different hardness, crystal structure and morphological characterizations, which can be optimized by the electrodepositing condition, i.e., the complexing agent and pH value in bath.

The correlations among the electrodepositing condition that varied with the complexing agent or pH value, the microstructure and the tribological properties of the deposited Co-W coatings were established. The differences of the tribological properties for Co-W coatings from different baths were attributed to their different hardness, crystal structure and morphological characterizations, which can be optimized by the electrodepositing condition, i.e., the complexing agent and pH value in bath.Highlights► The Co-W coatings were produced by dual-pulse electrodeposition from aqueous bath with cobalt sulphate and sodium tungstate. ► The correlation between the electrodepositing condition, the microstructure and the tribological properties of the Co-W deposits were established. ► The Co-W alloy coating obtained excellent tribological performances and high hardness by careful control of the electrodeposition condition.