In situ measurement of the surface stress evolution during magnetron sputter-deposition of Ag thin film

We measured the evolution of in situ surface stress of Ag thin film during the magnetron sputter deposition. The measurement of force per width of Ag thin film showed that both the surface state and surface stress of Ag layer can be controlled through the variation of the deposition conditions such as the deposition temperature and rate. At room temperature, the force per width curve of Ag film deposited to 1 Å/s showed a typical curve consisting of three stages of surface stress. A brief presence of initial compressive stage and broad tensile maximum resulting in a compressive state had a tendency to disappear with increasing the deposition temperature. Meanwhile, a development of final compressive stage was more at higher temperature. Similar effect was observed but less obvious on increasing the deposition rate.