Carbon dioxide-activated carbons from almond tree pruning: Preparation and characterization

Activated carbons were prepared from almond tree pruning by non-catalytic and catalytic gasification with carbon dioxide and their surface characteristics were investigated. In both series a two-stage activation procedure (pyrolysis at 800 °C in nitrogen atmosphere, followed by carbon dioxide activation) was used for the production of activated samples. In non-catalytic gasification, the effect of the temperature (650-800 °C for 1 h) and the reaction time (1-12 h at 650 °C) on the surface characteristics of the prepared samples was investigated. Carbons were characterized by means of nitrogen adsorption isotherms at 77 K. The textural parameters of the carbons present a linear relation with the conversion degree until a value of approximately 40%, when they come independent from both parameters studied. The highest surface area obtained for this series was 840 m2 g−1. In the catalytic gasification the effect of the addition of one catalyst (K and Co) and the gasification time (2-4 h) on the surface and porosity development of the carbons was also studied. At the same conditions, Co leads to higher conversion values than K but this last gives a better porosity development.