Effect of Zn on microstructure, texture and mechanical properties of Al-Mg-Si-Cu alloys with a medium number of Fe-rich phase particles

The effect of Zn on the microstructure, texture evolution and mechanical properties of Al-Mg-Si-Cu alloys with a medium number of Fe-rich phase particles was investigated using tensile testing machine, optical microscopy (OM), scanning electron microscope (SEM), transmission electron microscope (TEM) and X-ray diffractometer (XRD) in the present study. The results show that Zn addition has a significant influence on the final mechanical properties, but a slight effect on microstructure and final recrystallization texture. Zn addition is favorable to increase yield strength, ultimate tensile strength and elongation, however it is detrimental to improve r value and reduce Δr value. During the thermomechanical processing, the microstructure almost has nothing to do with Zn addition. However, Zn could prevent the secondary phase particles from precipitating during intermediate annealing. In contrast to the alloy sheet without Zn, the alloy sheet with 1.0 wt% Zn always has weaker textures before final cold rolling, but a stronger texture after experiencing final cold rolling. After solution treatment, they almost possess the same recrystallization texture. Finally, the effect of Zn addition on the recrystallization texture was discussed. Their similar recrystallization texture can be attributed to the similar microstructure, which was caused by the medium number of Fe-rich phase particles.