کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
5468139 | 1518927 | 2017 | 27 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Microstructure and mechanical properties of B4C/6061Al laminar composites fabricated by power metallurgy
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی مواد
سطوح، پوششها و فیلمها
پیش نمایش صفحه اول مقاله

چکیده انگلیسی
This study aims to investigate the effects of compositional gradient on microstructure and mechanical properties of a B4C/6061Al laminar composite fabricated using a powder metallurgy method - spark plasma sintering followed by extrusion and hot rolling. Results show that B4C particles were distributed fairly uniformly in the fabricated composites. Interfaces among different layers in the composites were bonded well and no porosity were observed in transition regions among different layers. The grains around B4C particles are smaller than those away from the B4C particles. Stress concentration is found to occur easily at the tip of the B4C particle, which facilitates the development of recrystallization nuclei. Compared with those of an extruded B4C/6061Al laminar composite, yield strength and ultimate tensile strength of the rolled B4C/6061Al laminar composite are obviously enhanced but its elongation to fracture is weakened. Two yielding points were observed in the rolled three-layer B4C/6061Al laminar composite due to the existence of B4C content gradient in the composite. Strengthening mechanisms in the fabricated laminar composites include grain refinement, dislocation strengthening, load transfer effect, and Orowan strengthening.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Vacuum - Volume 143, September 2017, Pages 363-370
Journal: Vacuum - Volume 143, September 2017, Pages 363-370
نویسندگان
Hong-sheng Chen, Wen-xian Wang, Hui-hui Nie, Jun Zhou, Yu-li Li, Peng Zhang,