Drop impact reliability of Sn–1.0Ag–0.5Cu BGA interconnects with different mounting methods

The poor drop-shock resistance of near-eutectic Sn–Ag–Cu (SAC) solder interconnects drives the research and application low-Ag SAC solder alloys, especially for Sn–1.0Ag–0.5Cu (SAC105). In this work, by dynamic four-point bend testing, we investigate the drop impact reliability of SAC105 alloy ball grid array (BGA) interconnects with two different surface mounting methods: near-eutectic solder paste printing and flux dipping. The results indicate that the flux dipping method improves the interconnects failure strain by 44.7% over paste printing. Further mechanism studies show the fine interfacial intermetallic compounds (IMCs) at the printed circuit board side and a reduced Ag content inside solder bulk are the main beneficial factors overcoming other negative factors. The flux dipping SAC105 BGA solder joints possess fine Cu6Sn5 IMCs at the interface of solder/Cu pads, which increases the bonding strength between the solder/IMCs and the fracture resistance of the IMC grains themselves. Short soldering time of flux dipping joints above the solder alloy liquidus mitigates the growth of interfacial IMCs in size. In addition, a reduced Ag content in flux dipping joint bulk causes a low hardness and high compliance, thus increasing fracture resistance under higher-strain rate conditions.