Effects of Large Saddle Panels on the Biomechanics of the Equine Back During Rising Trot: Preliminary Results

The saddle panels, directly in contact with the horse's back, are likely an important element to optimize the fitting of the saddle, the comfort of the horse, and subsequently, the pain management in dorsalgic horses. The aim of this study was to better understand the effect of the saddle panels on the horse's back, by evaluating a prototype saddle (comfort panels: CP) compared to a standard saddle (STD). The horse's back movements were measured using inertial measurement units (IMUs) fixed at the levels of thoracic vertebrae T6, T12, T16 (under the saddle) and lumbar vertebrae L2 and L5. The centers of mass (COMs) of the horse and the rider and limb's protraction-retraction angles, pressure between saddle and horse's back, and force on the stirrups were measured using respectively 2D motion capture, pressure mat and force sensors in the stirrup leather. Three horses were trotted at the rising trot (sitting: left diagonal-rider seated; standing: right diagonal-rider standing) by the same rider. To compare saddles, linear mixed-effects regression models were used. The estimated means (SE) were calculated. During sitting phase, pressure in the cranial and middle areas of the saddle significantly increased for CP compared to STD (+0.9 (0.2) kPa and +1.0 (0.1) kPa, respectively) whereas caudal pressure decreased (−1.8 (0.4) kPa). Concurrently, the range of motion of angles T12-T16 and T16-L2 under the saddle significantly increased (+1.8 (0.2)° and +2.3 (0.3)°, respectively). The results showed that modifications of the panels' shape not only affect the pressure distribution but also the kinematics of the thoracic and lumbar regions of the equine back.