Chlorodiethylaluminum supported on silica: A dinuclear aluminum surface species with bridging μ2-Cl-ligand as a highly efficient co-catalyst for the Ni-catalyzed dimerization of ethene

• Highly efficient supported co-catalysts for the Ni-catalyzed ethene dimerization.
• Silica-supported Et2AlCl co-catalysts prepared via Surface Organometallic Chemistry.
• Silica-supported dinuclear alkylaluminum species with μ2-Cl bridge.
• Characterization by high-fields 27Al SS-NMR and NMR signatures calculations using DFT.

Silica-supported chloro alkyl aluminum co-catalysts (DEAC@support) were prepared via Surface Organometallic Chemistry by contacting diethylaluminum chloride (DEAC) and high specific surface silica materials, i.e. SBA-15, MCM-41, and Aerosil SiO2. Such systems efficiently activate NiCl2(PBu3)2 for catalytic ethene dimerization, with turnover frequency (TOF) reaching up to 498,000 molC2H4/(molNi h) for DEAC@MCM-41. A detailed analysis of the DEAC@SBA-15 co-catalyst structure by solid-state aluminum-27 NMR at high-field (17.6 T and 20.0 T) and ultrafast spinning rates allows to detect six sites, characterized by a distribution of quadrupolar interaction principal values CQ and isotropic chemical shifts δiso. Identification of the corresponding Al-grafted structures was possible by comparison of the experimental NMR signatures with these calculated by DFT on a wide range of models for the aluminum species (mono- versus di-nuclear, mono- versus bis-grafted with bridging Cl or ethyl). Most of the sites were identified as dinuclear species with retention of the structure of DEAC, namely with the presence of μ2-Cl-ligands between two aluminum, and this probably explains the high catalytic performance of this silica-supported co-catalysts.

Figure optionsDownload high-quality image (103 K)Download as PowerPoint slide