Structural and adsorption characteristics and catalytic activity of titania and titania-containing nanomaterials

Morphological, structural, adsorption, and catalytic properties of highly disperse titania prepared using sulfate and pyrogenic methods, and fumed titania-containing mixed oxides, were studied using XRD, TG/DTA, nitrogen adsorption, 1H NMR, FTIR, microcalorimetry on immersion of oxides in water and decane, thermally stimulated depolarization current (TSDC) and catalytic photodecomposition of methylene blue (MB). Phase composition and aggregation characteristics of nanoparticles (pore size distribution) of sulfate and pyrogenically prepared titania are very different; temperature dependent structural properties are thus very different. Catalytic activity for the photodecomposition of MB is greatest (per gram of TiO2 for the pure oxide materials) for non-treated ultrafine titania PC-500, which has the largest SBETSBET value and smallest particle size of the materials studied. However, this activity calculated per m2 is higher for PC-105, possessing a much smaller SBETSBET value than PC-500. The activity per unit surface area of titania is greatest for the fumed silica–titania mixed oxide ST20. Calcination of PC-500 at 650 °C leads to enhancement of anatase content and catalytic activity, but heating at 800 and 900 °C lowers the anatase content (since rutile appears) and diminishes catalytic activity, as well as the specific surface area because of nanoparticle sintering.

XRD, TG/DTA, N2 adsorption, FTIR, NMR, microcalorimetry, TSDC, TPD/MS characterization and aqueous solution photocatalytic behavior.Figure optionsDownload as PowerPoint slide