کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
618004 | 881807 | 2011 | 7 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Influence of different surface modification technologies on friction of conformal tribopair in mixed and boundary lubrication regimes Influence of different surface modification technologies on friction of conformal tribopair in mixed and boundary lubrication regimes](/preview/png/618004.png)
Moving machine assemblies are generally designed to operate in full film lubrication regime to ensure high efficiency and durability of components. However, it is not always possible to ensure this owing to changes in operating conditions such as load, speed, and temperature. The overall frictional losses in machines are dependent on the operating lubrication regimes (boundary, mixed or full-film). The present work is thus aimed at investigating the role of different surface modification technologies on friction of a sliding bearing/roller tribopair both in boundary and mixed lubrication regimes. A special test rig comprising of two bearings was built for the experimental studies. Tribological tests were conducted in a wide speed range to enable studies in boundary and mixed lubrication regimes. The influence of application of different surface modification technologies on both the sliding bearing and the roller surfaces on friction has been studied. The rollers used in these studies were provided with five different coatings (hard DLCs and a soft self-lubricating coating). Additionally, two uncoated rollers having different surface roughness were also studied. Uncoated bearings were used in all tribopairs except two. These two bearings were coated with DLC and phosphate coatings respectively and uncoated rollers were the mating counterparts. Friction measurements were made on the new as well as the previously run-in surfaces. It was found that the rollers with self-lubricating coating resulted in lowest boundary friction closely followed by the rollers with the hardest DLC coatings. The DLC coating applied on to the bearing showed lower boundary friction after running-in. Mixed friction has been found to be mainly dependent on the surface topography characteristics of both the original and the run-in surfaces of bearings and rollers. The harder DLC coatings and the phosphated bearing showed the lowest mixed friction due to an efficient running-in of the bearing surface.
► Friction coefficient in mixed lubrication regime can be reduced by effective running-in or by polish the surfaces before test.
► Effective running-in can be achieved by using hard DLC coatings on journal or soft phosphate coating on bearing.
► Running-in gives lower friction in mixed regime compared to polished surfaces before test.
Journal: Wear - Volume 273, Issue 1, 1 November 2011, Pages 75–81