کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
6683072 501852 2016 11 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Hydrate dissociation induced by depressurization in conjunction with warm brine stimulation in cubic hydrate simulator with silica sand
ترجمه فارسی عنوان
اختلاط هیدرات ناشی از کم فشار سازی همراه با تحریک شور آب گرم در شبیه ساز هیدرات مکعبی با ماسه سیلیس
کلمات کلیدی
هیدرات کاهش فشار، تحریک حرارتی، آب نمک گرم، غلظت شور،
ترجمه چکیده
برای بررسی اثر غلظت نمک تزریق نمک بر محلول سازی هیدرات، آزمایشات جداسازی هیدراته ناشی از کاهش فشار همراه با تحریک شور آب گرم در یک شبیه ساز هیدرات کربنی انجام شده است. چاه های افقی دوگانه به عنوان پیکربندی خوب تنظیم شده است. نتایج نشان می دهد که شوری در مخزن به طور مداوم در طول مرحله کمپرسازی تحت مخلوط آب تازه از جداسازی هیدرات متداول کاهش می یابد. با این حال، شور و شوق در طول مرحله ثابت فشار (مرحله تزریق) با اضافه شدن محلول جامد به محلول تزریقی اضافه می شود. میزان تولید گاز و میزان انتقال گرما برای تزریق آب خالص پایین تر از تزریق آب شور است. علاوه بر این، افزایش شوری تزریقی می تواند میزان انتقال حرارت و تولید گاز را در زمانی که شوری پایین تر از 10.0٪ است، افزایش دهد. با این حال، اثر تبلیغی تزریق نمک بر محلول هیدرات محدود است، زمانی که شور شورا تزریق بیش از 10.0٪ است. این به این دلیل است که حرارت خاصی از آب نمک با افزایش شوری کاهش می یابد که باعث کاهش میزان تزریق گرما می شود. میزان تولید آب به میزان تزریق آب در فرایند تزریق آب شور برابر است. تجزیه و تحلیل انرژی و ارزیابی نسبت انرژی نشان می دهد که شوری مطلوب تزریق شده در این کار 10.0٪ است.
موضوعات مرتبط
مهندسی و علوم پایه مهندسی انرژی مهندسی انرژی و فناوری های برق
چکیده انگلیسی
To study the effect of salt concentration of brine injection on hydrate dissociation, hydrate dissociation experiments induced by depressurization in conjunction with warm brine stimulation have been carried out in a Cubic Hydrate Simulator (CHS). The dual horizontal wells were set as the well configuration. The results indicate that the salinity in the reservoir decreases continuously during the depressurizing stage under the mixture of fresh water from hydrate dissociation. However, the salinity increases overtime during the constant-pressure stage (the injection stage) by the mass transfer with the injected brine. The gas production rate and heat-transfer rate for pure water injection are lower than those for brine injection. In addition, raising the injected salinity can enhance the rates of heat transfer and gas production when the salinity is lower than 10.0%. However, the promotion effect of brine injection on hydrate dissociation is limited when the injected salinity is beyond 10.0%. This is because the specific heat of the brine declines with the increase of the salinity, which causes the decrease of heat injection rate. The water production rate equals to the water injection rate in the process of brine injection. The energy analysis and the evaluation of energy ratio indicate that the optimal injected salinity in this work is 10.0%.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Applied Energy - Volume 174, 15 July 2016, Pages 181-191
نویسندگان
, , ,