Detection process approach of tool wear in high speed milling

The cutting tool wear degrades the quality of the product in the manufacturing process, for this reason an on-line monitoring of the cutting tool wear level is very necessary to prevent any deterioration. Unfortunately there is no direct manner to measure the cutting tool wear on-line. Consequently we must adopt an indirect method where wear will be estimated from the measurement of one or more physical parameters appearing during the machining process such as the cutting force, the vibrations, or the acoustic emission, etc. The main objective of this work is to establish a relationship between the acquired signals variation and the tool wear in high speed milling process; so an experimental setup was carried out using a horizontal high speed milling machine. Thus, the cutting forces were measured by means of a dynamometer whereas; the tool wear was measured in an off-line manner using a binocular microscope. Furthermore, we analysed cutting force signatures during milling operation throughout the tool life. This analysis was based on both temporal and frequential signal processing techniques in order to extract the relevant indicators of cutting tool state. Our results have shown that the variation of the variance and the first harmonic amplitudes were linked to the flank wear evolution. These parameters show the best behavior of the tool wear state while providing relevant information of this later.