Polymethylmethacrylate-based luminescent solar concentrators with bottom-mounted solar cells

• Bottom-mounted luminescent solar concentrators on dye-doped plates were studied.
• The mechanism of transport process was proposed.
• The fabricated luminescent solar concentrator achieved a gain of 1.38.
• Power conversion efficiency of 5.03% was obtained with cell area coverage of 27%.
• The lowest cost per watt of $1.89 was optimized with cell area coverage of 18%.

Luminescent solar concentrators offer an attractive approach to concentrate sunlight economically without tracking, but the narrow absorption band of luminescent materials hinders their further development. This paper describes bottom-mounted luminescent solar concentrators on dye-doped polymethylmethacrylate plates that absorb not only the waveguided light but also the transmitted sunlight and partial fluorescent light in the escape cone. A series of bottom-mounted luminescent solar concentrators with size of 78 mm × 78 mm × 7 mm were fabricated and their gain and power conversion efficiency were investigated. The transport process of the waveguided light and the relationship between the bottom-mounted cells were studied to optimize the performance of the device. The bottom-mounted luminescent solar concentrator with cell area coverage of 9% displayed a cell gain of 1.38, to our best knowledge, which is the highest value for dye-doped polymethylmethacrylate plate luminescent solar concentrators. Power conversion efficiency as high as 5.03% was obtained with cell area coverage of 27%. Furthermore, the bottom-mounted luminescent solar concentrator was found to have a lowest cost per watt of $1.89 with cell area coverage of 18%. These results suggested that the fabricated bottom-mounted luminescent solar concentrator may have a potential in low-cost building integrated photovoltaic application.

Figure optionsDownload as PowerPoint slide