کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
7890875 1509885 2016 10 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Analysis of the thermomechanical shear behaviour of woven-reinforced thermoplastic-matrix composites during forming
ترجمه فارسی عنوان
تجزیه و تحلیل رفتار برشی ترموموکانیکی کامپوزیت های ترموپلاستیک-ماتریکس تقویت شده بافته شده در طول تشکیل
ترجمه چکیده
رفتار برش یک کامپوزیت شیشه ای / پلی پروپیلن در طیف گسترده ای از نرخ فشار و دمای تشکیل شده با استفاده از آزمون گسترش انحرافی مشخص می شود. مدل زندگی وابسته به دما و سرعت در اینجا برای توصیف رفتار مشاهده شده معرفی شده است. این مدل بر مبنای یک رویکرد پیوسته است و با توجه به مشتقات هدف استرس براساس چرخش نخ و طناب صورت می گیرد. اثرات درجه حرارت و نرخ فشار بر رفتار برشی با استفاده از شبیه سازی های آزمایش فرکانس بی اختیاری تجزیه می شود. تغییر دما در ورق در طی تشکیل اندازه گیری شد. این داده ها برای خنک کردن مدل در شکل گیری استفاده می شود. برای نشان دادن اثرات دما و شکل گیری سرعت بر روی توزیع زاویه برشی بدست آمده، شبیه سازی های ایزوترمال و گذرا انجام شد. مشخص شد که در شکل گیری سرعت کم، فرض شکل گیری ایزوترمال بیشتر از زمان معتبر نیست زیرا خنک کننده ورقه بر رفتار برش اثر می گذارد.
موضوعات مرتبط
مهندسی و علوم پایه مهندسی مواد سرامیک و کامپوزیت
چکیده انگلیسی
Shear behaviour of a glass fibre/polypropylene composite is characterized over a wide range of strain rates and forming temperatures using the bias extension test. A temperature- and rate-dependent material model is here introduced to describe the observed behaviour. The model is based on a continuous approach and formulated considering a stress objective derivative based on the warp and weft yarns rotation. The effects of temperature and strain rate on the shear behaviour are analysed via bias extension test simulations. Temperature change in the sheet during forming was measured. This data is used to model cooling during forming. Isothermal and transient forming simulations were performed in order to show the effects of temperature and forming speed on the obtained shear angle distribution. It was found that at low forming speeds the assumption of isothermal forming is not valid anymore since the cooling of the sheet affects the shear behaviour.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Composites Part A: Applied Science and Manufacturing - Volume 86, July 2016, Pages 39-48
نویسندگان
, , , ,