Quantitative characterization of porosity in Fe–Al dissimilar materials lap joint made by gas metal arc welding with different current modes

5052 Al alloy sheets and galvanized mild steel sheets were joined by gas metal arc welding with three different current modes, including direct-current pulse gas metal arc welding (DPG), alternate-current pulse gas metal arc welding (APG) and alternate-current double pulse gas metal arc welding (ADG). The effect of current mode on size, distribution and volume fraction of pores generated in Fe–Al dissimilar materials lap joint was quantitatively studied. EDS result showed that pores in Fe–Al joint were mainly caused by trapped zinc metal vapor from galvanized steel. Volume fraction of pores in joints made by APG and ADG processes was larger than that in joint resulted from DPG process. Moreover, pores in joints made by APG and ADG processes had smaller diameter, and tended to distribute in the middle of the weld seam. On the contrary, pores with large diameter were inclined to distribute close to upper weld surface of the joint resulted from DPG process. These results are attributed to the difference of arc stirring force and linear heat input in these three processes caused by different current modes.