Blast loading response of reinforced concrete panels reinforced with externally bonded GFRP laminates

The behavior of reinforced concrete panels, or slabs, retrofitted with glass fiber reinforced polymer (GFRP) composite, and subjected to blast load is investigated. Eight 1000 × 1000 × 70 mm panels were made of 40 MPa concrete and reinforced with top and bottom steel meshes. Five of the panels were used as control while the remaining four were retrofitted with adhesively bonded 500 mm wide GFRP laminate strips on both faces, one in each direction parallel to the panel edges. The panels were subjected to blast loads generated by the detonation of either 22.4 kg or 33.4 kg ANFO explosive charge located at a 3-m standoff. Blast wave characteristics, including incident and reflected pressures and impulses, as well as panel central deflection and strain in steel and on concrete/FRP surfaces were measured. The post-blast damage and mode of failure of each panel was observed, and those panels that were not completely damaged by the blast were subsequently statically tested to find their residual strength. It was determined that overall the GFRP retrofitted panels performed better than the companion control panels while one retrofitted panel experienced severe damage and could not be tested statically after the blast. The latter finding is consistent with previous reports which have shown that at relatively close range the blast pressure due to nominally similar charges and standoff distance can vary significantly, thus producing different levels of damage.