Processing of a new high strength high toughness steel with duplex microstructure (Ferrite + Austenite)

In this investigation a new third generation advanced high strength steel (AHSS) has been developed. This steel was synthesized by austempering of a low carbon and low alloy steel with high silicon content. The influence of austempering temperature on the microstructure and the mechanical properties including the fracture toughness of this steel was also examined. Compact tension and cylindrical tensile specimens were prepared from a low carbon low alloy steel and were initially austenitized at 927 °C for 2 h and then austempered in the temperature range between 371 °C and 399 °C to produce different microstructures. The microstructures were characterized by X-ray diffraction, scanning electron microscopy and optical metallography. Test results show that the austempering heat treatment has resulted in a microstructure consisting of very fine scale bainitic ferrite and austenite. A combination of very high tensile strength of 1388 MPa and fracture toughness of 105 MPa √m was obtained after austempering at 371 °C.

► This new steel has exceptional combination of high strength and fracture toughness.
► Austempering treatment resulted in a very fine scale bainitic ferrite microstructure.
► As the austempering temperature increases yield strength and toughness decreases.
► Maximum fracture toughness of 105 MPa √m is obtained after austempering at 371 °C.
► A relationship between fracture toughness and the parameter σy(XγCγ)1/2 was observed.